| CAJ Innovations Forums | |
|
https://www.cajinnovations.com.au/forum/YaBB.pl
MyECU >> MyECU Advanced usage >> Tacho output https://www.cajinnovations.com.au/forum/YaBB.pl?num=1250503465 Message started by jocke on 08/17/09 at 20:04:25 |
|
|
Title: Tacho output Post by jocke on 08/17/09 at 20:04:25
How does the tacho output work? The reason that I am asking is that I have an innovate LM-2 that I am trying to log with.
Earlier I have used the LM-1 and it picks up the signals good but the problem is that the LM-2 is famous for having problem to log a clean RPM. I tried a clamp on the igition lead but the RPM is jumping up and down on the LM-2. I tried to connect the negativ lead the the coil. Does not work. I was thinking that it might be possible to use the tacho signal. What is it? A square? What is the frequense? Is it the same as the RPM? Jocke.......... |
|
Title: Re: Tacho output Post by raz on 08/18/09 at 02:35:14
I have a note (from the v11lemans forum somewhere) it's square wave, 2 pulses per revolution. So 37 Hz is 1100 rpm, 267 Hz is 8000 rpm. I'm not really sure if this is correct.
|
|
Title: Re: Tacho output Post by raz on 09/04/09 at 01:16:44
Any success? Please report!
|
|
Title: Re: Tacho output Post by jocke on 10/07/09 at 22:00:40 raz wrote on 09/04/09 at 01:16:44:
Sorry. Did not have time to play with my bike at all. My dirtbike have been keeping me buissy. Jocke........ |
|
CAJ Innovations Forums » Powered by YaBB 2.4! YaBB © 2000-2009. All Rights Reserved. |