| CAJ Innovations Forums | |
|
https://www.cajinnovations.com.au/forum/YaBB.pl
MyECU >> Getting started with MyECU >> My16 Ignition coil driver. https://www.cajinnovations.com.au/forum/YaBB.pl?num=1254917526 Message started by jocke on 10/07/09 at 22:12:06 |
|
|
Title: My16 Ignition coil driver. Post by jocke on 10/07/09 at 22:12:06
On MY16. Pin 1 and 19 that goes to the ignition coil to control it. Is it a switching ground or a voltage. If a voltage how high is it?
It is a bit strange to me as it sais on the MYECU page that ignition and injector drivers works the same. When I look at the wiring manual for my bike the injectors are controled by a switching ground so if that is correct the ignition should also be controlled by switching ground. The reason that I am asking is that I try to get a reliable RPM reading for my LM-2 lambda meter. Now it is configured for switching ground but it does not read any thing at all. Is it a switching power insteady? Jocke........... |
|
Title: Re: My16 Ignition coil driver. Post by raz on 10/08/09 at 05:13:23
The coils and injectors all have a constant 12V from the power relay and the 16M drivers grounds them when active.
|
|
CAJ Innovations Forums » Powered by YaBB 2.4! YaBB © 2000-2009. All Rights Reserved. |