| CAJ Innovations Forums | |
|
https://www.cajinnovations.com.au/forum/YaBB.pl
MyECU >> Getting started with MyECU >> Setting the TPS https://www.cajinnovations.com.au/forum/YaBB.pl?num=1312661795 Message started by coldnorth on 08/07/11 at 06:16:35 |
|
|
Title: Setting the TPS Post by coldnorth on 08/07/11 at 06:16:35
Here comes a potensiell stupid question.I tought I should check the TPS output and eventually adjust if not correct.I know where to mesure and the value,but howe the fu... do I get to the pins on the sensor with the socket attatced?
|
|
Title: Re: Setting the TPS Post by Mad Farquhar on 08/07/11 at 13:03:35
If you have a MyECU then you can use its output on the computer or an Optimiser to determine the TPS voltage (IIRC it's 1 MyECU TPS "unit" = 5mV). See this thread (there are others too):-
http://cajinnovations.com/yabb0/YaBB.pl?num=1250500728 or if you want to go the original pre-MyECU way use fine strong wire to poke up the plug - I have used plasticised garden wire - the stuff that holds flowers to stakes / fences and the like. There is a write up on the guzzitech website I think. edit: here is some info on sticking pins in your http://www.v11lemans.com/forums/index.php?showtopic=12204 |
|
Title: Re: Setting the TPS Post by coldnorth on 08/07/11 at 19:06:34
Thank you Mad Farquhar,most helpfull.I have thougt of somethink like that myself,but wasn't shure if possible.
|
|
CAJ Innovations Forums » Powered by YaBB 2.4! YaBB © 2000-2009. All Rights Reserved. |