| CAJ Innovations Forums | |
|
https://www.cajinnovations.com.au/forum/YaBB.pl
MyECU >> Getting started with MyECU >> crankshaft position sensor https://www.cajinnovations.com.au/forum/YaBB.pl?num=1316295292 Message started by samurai on 09/18/11 at 07:34:52 |
|
|
Title: crankshaft position sensor Post by samurai on 09/18/11 at 07:34:52
I used to have a Marelli in my cagiva grand canyon,( ducati 904cc engine) and it worked ok but with the all known problem, so I acquired a Myecu Kit, BUT!! it did not worked, :'( Cliff kindly offer to check it for me and once it returned from AUTRALIA!! I am in Central América, It did not work again.... :(
The issue, Marelli is a litle more sensitive and my Crank Shaft pulse was a litle out of limit!! :-? so My ecu did not worked solidly. Cure: set the factory gap and voila! Since then my ecu work as an angel. :) |
|
Title: Re: crankshaft position sensor Post by YaBB Administrator on 09/18/11 at 07:42:36
Did you need to increase or decrease the signal?
|
|
Title: Re: crankshaft position sensor Post by samurai on 09/20/11 at 05:03:57
The signal was increased, the gap was almost 3 mm so I took the spacer out and now is .7 mm.
|
|
CAJ Innovations Forums » Powered by YaBB 2.4! YaBB © 2000-2009. All Rights Reserved. |