CAJ Innovations Forums

CAJ Innovations Forums
https://www.cajinnovations.com.au/forum/YaBB.pl MyECU >> MyECU Advanced usage >> Problem setting comm port in EcuContoller https://www.cajinnovations.com.au/forum/YaBB.pl?num=1378497963 Message started by Bobd on 09/07/13 at 06:06:03

Title: Problem setting comm port in EcuContoller
Post by Bobd on 09/07/13 at 06:06:03

I have a feeling I have had this problem before but can't remember how I sorted it. Had a look through my old post without success.

Device manager shows my USB Serial port to be on comm6. I cannot get MyEcuController 1.66 to change from comm1, I try to set it to comm6 but it wont stay there. I had a look with Hyperterminal and comm6 seems to be connected OK to the My15M.

Title: Re: Problem setting comm port in EcuContoller
Post by YaBB Administrator on 09/07/13 at 06:53:02

If you're on win7 this is generally permissions related.
From explorer right click on the ECUController and select "run as administrator" This should allow you then to select the right port.
This should only be required once.

Title: Re: Problem setting comm port in EcuContoller
Post by Bobd on 09/07/13 at 08:50:32

Many thanks Cliff, worked a treat.

Been doing a lot of DIY and work in general lately so MY15M has been on the back burner.

Off to the Netleymarsh Autojumble tommorow and perhaps Beaulieu if I can find the cash, you never know I may find some Guzzi bits there.