CAJ Innovations Forums - 15m o2 sensor cable question

05/10/25 at 19:31:41

	Welcome, Guest. Please Login or Register
	Welcome to our forum.

Home

Help

CAJ Innovations Forums › MyECU › Getting started with MyECU › 15m o2 sensor cable question

(Moderators: _Cliff_, YaBB Administrator)

‹ Previous Topic | Next Topic ›

Pages: 1

15m o2 sensor cable question (Read 2769 times)

Quattroporte YaBB Newbies Offline I love MyECU! Posts: 39	15m o2 sensor cable question 03/25/10 at 04:01:23 I have a 04 v11sport 15m without the lambda sensor but there is a connector near the ecu that looks like one for it. Is that plug wired into the ecu (now My15m).... and can I then use that with an lc-1 sensor? or should I just use the pcb plug connection? Thanks for your suggestions..... Charles
Back to top	« Last Edit: 03/25/10 at 04:01:54 by Quattroporte » IP Logged

YaBB Administrator YaBB Administrator Offline I love YaBB! Posts: 679 The Land of YaBB	Re: 15m o2 sensor cable question Reply #1 - 03/25/10 at 05:01:18 I don't know about the plug. You could check continuity to the 3 pin header on the MyECU PCB.
Back to top	The Administrator. IP Logged

raz

Senior Member

Offline

Guzzi 11OO Sport, My16MkV,
Innovate LC-1

Posts: 373
Stockholm, Sweden
Gender: male

Re: 15m o2 sensor cable question
Reply #2 - 03/25/10 at 05:18:01

Hubert mentioned using the diagnostic connector for his own needs, maybe it's that one? After he gave me the idea I did the same with my 16M, which has a similar one. I only had to make one little patch inside the ECU from the corresponding pin to the sensor connector block. Ground was already supplied.

The LC-1 needs its own, good, 12V power. I feed mine from my power relay so it's only powered when the fuel pump is running.

59° North
1100 Sport iniezione elettronica -- the perfect merge of a superbike and a steam train

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page