CAJ Innovations Forums - Problem setting comm port in EcuContoller

05/11/26 at 15:14:18

	Welcome, Guest. Please Login or Register
	Welcome to our forum.

Home

Help

CAJ Innovations Forums › MyECU › MyECU Advanced usage › Problem setting comm port in EcuContoller

(Moderators: _Cliff_, YaBB Administrator)

‹ Previous Topic | Next Topic ›

Pages: 1

Problem setting comm port in EcuContoller (Read 3698 times)

Bobd

Full Member

Offline

I am slowly developing
a relationship with MyEcu.

Posts: 150
Southampton
Gender: male

Problem setting comm port in EcuContoller
09/07/13 at 06:06:03

I have a feeling I have had this problem before but can't remember how I sorted it. Had a look through my old post without success.

Device manager shows my USB Serial port to be on comm6. I cannot get MyEcuController 1.66 to change from comm1, I try to set it to comm6 but it wont stay there. I had a look with Hyperterminal and comm6 seems to be connected OK to the My15M.

« Last Edit: 09/07/13 at 06:06:30 by Bobd »

IP Logged

YaBB Administrator YaBB Administrator Offline I love YaBB! Posts: 686 The Land of YaBB	Re: Problem setting comm port in EcuContoller Reply #1 - 09/07/13 at 06:53:02 If you're on win7 this is generally permissions related. From explorer right click on the ECUController and select "run as administrator" This should allow you then to select the right port. This should only be required once.
Back to top	The Administrator. IP Logged

Bobd Full Member Offline I am slowly developing a relationship with MyEcu. Posts: 150 Southampton Gender:	Re: Problem setting comm port in EcuContoller Reply #2 - 09/07/13 at 08:50:32 Many thanks Cliff, worked a treat. Been doing a lot of DIY and work in general lately so MY15M has been on the back burner. Off to the Netleymarsh Autojumble tommorow and perhaps Beaulieu if I can find the cash, you never know I may find some Guzzi bits there.
Back to top	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page