Does any one know where it is possible to get the terminal pins to the ECU connector? The pins in the wiring harness.

I have this idea that I could use some of the unused pins (13 are not used on P16) to connect my dual lambda, The RJ45 connector and the 4 switches.

All in all I would use 5 pins for the switches, 3 pins for the lambdas and 4 pins for the RJ45 connector. I would still have one unused pin.

I could seal up the ECU forever and never have to open it again and I could have nice water proof OMP connectors(the original connectors) for the switches, lambdas and RJ45.

As the switches would be installed externaly I could change there positions in seconds. I could have a permanent wiring installation for my dual lambda and for the optimizer and just hook it up in a minute when I want it.

Does this make sense?

So back the the question. Where can I find the pins?

Jocke...........