Hi all this is a bit long winded.... but here goes

I have managed to upload the map from my OEM ECU, or at least a mate of a mate has managed to.  I have the file and can open it in the "PSPad editor" program that has been recomended for map editing elsewhere on this forum. 

The file is listed as a Hex file on its properties page

I can also read the Sport 1100 map as a Hex file using the PSPad editor program.  This file is listed as an ECU file on its properities page

I cannot however load the OEM map Hex file into the ECUControl 143 program for loading into the "My ECU 16M".

Is it posiable to reformat the OEM Hex file so that the ECUControl 143 software can read and accept it?

I don't understand much of this and am parroting a lot but I'm hopping to start with the OEM map, which is actually a "Fuel Injected Motorcycle" map and not an OEM map at all.  It is however the map that came with the bike when I purchased it as a demo model, equiped with aftermarket exhusts.

2001 Ducati 748R with Termogini pipes. 

Sorry but I am a bit of a computer dill and am not real confident starting with the guzzi sport map.  Much lower redline for a start.

All and any help appreicated along with smart, witty even sarcastic  comments

Wayne Orwigs proggy shows you only the main fuel map if i remember correctly. That's not enough for your purposes. It'll give you no info about pressure, temp, deadtime e.a. correction tables.
You'll get more for your spent daytime if you take a standard Duc map (available here from someone?) and adjust that to your needs.

You own a wideband O2 probe?

Hubert

Thanks for the replies fellas

I located the Wayne Orwig site a couple of days ago, same link as you posted Raz, and downloaded both Zip files.  Unfortunately I cannot open them as I suspect they're for an eariler version of Windows.  They open as a blank black screen for about 1/2 a second then dissappear completely.

I have downloaded Andrew Balls program and will attempt using that presently.

Luhdo, I don't have an O2 probe.  Should I?  My bike operates in open loop and thus has no O2 sensor.  I plan to install an O2 sensor and investigate closed loop operation later, much much later LOL

I allready have the original map just cant load the bugger into the ECU Controller.  If someone here has a correctly formatted map for a Ducati 748R 2001 that they could post I'd be most obliging.  This is a steep learning curve for me.  I'm ok with Dellorto's but EFI and ECU's not so good.

Thanks again

Ball`s software works.
I  don`t think any software converts .bin to .ecu files f EcuControl, you`ll have to transfer data yourself.

I have 907 & ST4s maps f MyECU & 916 as textfile if you want.