CAJ Innovations Forums - Setting the TPS

05/10/25 at 21:28:02

	Welcome, Guest. Please Login or Register
	Welcome to our forum.

Home

Help

CAJ Innovations Forums › MyECU › Getting started with MyECU › Setting the TPS

(Moderators: YaBB Administrator, _Cliff_)

‹ Previous Topic | Next Topic ›

Pages: 1

Setting the TPS (Read 3180 times)

coldnorth YaBB Newbies Offline I love MyECU! Posts: 7	Setting the TPS 08/07/11 at 06:16:35 Here comes a potensiell stupid question.I tought I should check the TPS output and eventually adjust if not correct.I know where to mesure and the value,but howe the fu... do I get to the pins on the sensor with the socket attatced?
Back to top	IP Logged

Mad Farquhar

Full Member

Offline

Slainthe mhath

Posts: 171
Black Isle, Scotland
Gender: male

Re: Setting the TPS
Reply #1 - 08/07/11 at 13:03:35

If you have a MyECU then you can use its output on the computer or an Optimiser to determine the TPS voltage (IIRC it's 1 MyECU TPS "unit" = 5mV). See this thread (there are others too):-
http://cajinnovations.com/yabb0/YaBB.pl?num=1250500728
or if you want to go the original pre-MyECU way use fine strong wire to poke up the plug - I have used plasticised garden wire - the stuff that holds flowers to stakes / fences and the like. There is a write up on the guzzitech website I think.
edit: here is some info on sticking pins in your ~~eyes~~ er.. sorry.. your tps.

http://www.v11lemans.com/forums/index.php?showtopic=12204

« Last Edit: 08/07/11 at 17:12:37 by Mad Farquhar »

MG Sport 1100 inj
Triking
Honda ST1100
V7 Stone

IP Logged

coldnorth YaBB Newbies Offline I love MyECU! Posts: 7	Re: Setting the TPS Reply #2 - 08/07/11 at 19:06:34 Thank you Mad Farquhar,most helpfull.I have thougt of somethink like that myself,but wasn't shure if possible.
Back to top	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page